Features:

• Precise pressure calibration of standard surface area jaw face
• Individual panel mounted controllers for temperature, pressure and dwell/delay times.
• Jaws constructed in aluminium and silicon with precision ground faces
• Range of jaw face surfaces including Matched Crimp and Teflon Coating
• Alarm package to monitor and inhibit operation when temperature or pressure out of specification
• Lockable Perspex front cover to protect machine settings
• Optional auto-cycle and delay timer

Benefits:

• Choose heat sealing bar configuration, either single (upper) or dual (upper & lower, meets ASTM F2029)
• Extra wide sealing jaws for heat seals up to 800mm long
• Accurate and repeatable seals due to precision ground sealing faces and jaw guidance system
• Versatile applications for flexible materials, porous and non-porous films, foils and blister packs
• Low Maintenance – 12 months between calibrations

HS-800 Medical Heat Sealer meets the following standard: ASTM F2029

RDM Heat Sealers have set the standard in precision and reliability for over 30 years. Please Contact Us and we’ll work with you to understand your requirements and provide a solution.

Models
HS-800 Single—Upper jaw temperature controlled HS-800 Dual—Upper & Lower jaw
temperature controlled.

Seal Width
Up to 800mm max.

Controller
Individual panel mounted controllers for temperature, pressure and dwell times.
Optional footswitch operation.

Temperature Control
Range: Ambient to 300°C, Accuracy: +/- 0.5%, Operating Accuracy: +/-2°C. User definable
alarm for over/under set level.

Pressure
Range: 0 to 100psi (6.8bar, 689Kpa), via digital pressure gauge, pressure control via
precision regulator. Accuracy +/-5%. User definable alarm for over/under set level. Supply via
clean and dry compressed airline or bottled air/nitrogen at 75 to 115psi.

Dwell Time
Range: 0.1 to 99.9 sec., Resolution 0.1 sec. Accuracy +/-5%.

Delay Time
Delay Time Range: 0.1 to 99.9 sec.

Jaw Alignment System
Jaw alignment for even closure, resulting in consistently high quality seals.

Sealing Jaws
Standard flat jaws 10mm x 800mm, constructed in aluminium with precision ground face. Lower
sealing jaw with precision ground silicone rubber face. (See options below).

Environment
5-50°C ambient operating temperature, RH 75% max (noncondensing).

Power
240V AC 50/60 Hz (110V AC available on request).

Options
Sealing jaw dimension/profile as required (inc. Matched crimp 120° x 1.8mm pitch).
Teflon Coated Tape or Teflon Coated Jaws.
Auto Cycle runs machine continuously, with delay time between cycles.
Guillotine cutter.
Validation documentation / service.